Traillering - TOHATSU EverRun MX 25H Owner's Manual

42
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
8
1. Handle
ENOM00072-A

3. Traillering

ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOF01827-0
1
ENOF01815-0
CAUTION
ENOW00073-A
WARNING
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-1
WARNING
Close air vent screw on fuel tank and fuel
cock before carrying or storing outboard
motor and/or fuel tank, or fuel may leak,
potentially catching fire.
ENOW00071-0
CAUTION
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor still attached,
disconnect the fuel line from the out-
board motor beforehand and keep the
outboard motor in the vertical or on a
transom saver bar.
Tiller handle type
While transpor ting outboard motor
attached to the boat on a trailer, properly
tighten the steering friction bolt to pre-
vent the outboard motor from moving
(page 44).
ENOF00075-1