Table of Contents
Advertisement
60
INSPECTION AND MAINTENANCE
ENOM00100-A
3. Off-season storage
ENOW00934-0
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00097-0
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
d an c e w i t h l o c a l f ir e pr e ve n t i o n an d
environment protection regulations.
ENOW00096-0
Before servicing the motor for storage:
Remove the battery cables.
Remove the spark plug caps from the
spark plugs.
Do not run the motor out of the water.
Before you put your outboard motor in
storage, it is a good opportunity to have
it serviced by your dealer.
10
Be sure to use fuel stabilizer while run-
ning the motor before storage. (See
page 61)
ENOM00101-C
Engine
1. Wash the engine exterior and flush
the cooling water system thoroughly
with fresh water. Drain the water
completely.
Wipe off any surface water with an
oily rag.
WARNING
WARNING
CAUTION
2. Remove the fuel hose from the out-
board motor.
3. Drain all fuel from the fuel hoses, fuel
pump, fuel filter (See page 53) and
carburetor (See page 62), and clean
these parts.
Keep in mind that if residue in the
carburetor for a long time, gum and
varnish will develop, causing the float
valve to stick, restricting the fuel flow.
4. Remove the spark plugs and put a
teaspoon of engine oil or spray stor-
age oil into the combustion chamber
through the spark plug holes.
5. Pull the recoil starter several times to
lubricate inside the cylinder.
ENOW00930-1
WARNING
Be sure to remove stop switch lock to
prevent the spark plugs from igniting.
Put a cloth to spark plug hole and wipe up
any spilled engine oil, when cranking the
outboard motor.
6. Change the gear oil in the gear case
(See page 54).
7. Apply grease to grease point (See
page 59).
Advertisement
Table of Contents
