Front Control Panel - Supero 7043M-6 User Manual

6-2

Front Control Panel

The front control panel must be connected to the JF2 connector on the mother-
board to provide you with system status and alarm indications. A ribbon cable
has bundled these wires together to simplify this connection. Connect the cable
from JF2 on the motherboard (making sure the red wire plugs into pin 1) to the
appropriate comnnector on the front control panel PCB (printed circuit board).
Pull all excess cabling over to the control panel side of the chassis. The LEDs
inform you of system status - see Figure 6-2 for details. Figure 6-1 is a front view
of the chassis, which shows the chassis features and the drive bay setup.
Power
HDD
NIC1
NIC2
Overheat
Power Fail
Figure 6-2. Front Control Panel LEDs
Indicates power is being supplied to the system.
Indicates IDE hard disk/CD-ROM drive activity.
Indicates network activity on LAN Port 1 (Mb LAN).
1
2 Indicates network activity on LAN Port 2 (Gb LAN).
Indicates an overheat condition in either one of the
processors.
Indicates a power supply failure.
Chapter 6: Advanced Chassis Setup
6-3