Connecting The Control Panel - Supero 7043M-6 User Manual

S S
UPER ERVER 7043M-8/7043M-6 Manual

Connecting the Control Panel

JF2 contains header pins for various front control panel connectors.
Figure 5-3 for the pin locations of the various front control panel buttons
and LED indicators. Please note that even and odd numbered pins are on
opposite sides of each header.
All JF2 wires have been bundled into single ribbon cable to simplify their
connection. Make sure the red wire plugs into pin 1 as marked on the
board. The other end connects to the Control Panel printed circuit board,
located just behind the system status LEDs in the chassis.
See the Connector Definitions section in this chapter for details and pin
descriptions of JF2.
Figure 5-3. Front Control Panel Header Pins
Overheat LED
Power Fail LED
Ground
X
Power LED
HDD LED
NIC1 LED
X
Ground
Ground
20 19
NMI
X
Vcc
Vcc
Vcc
X
Vcc
Vcc
Reset
Pwr
2 1
5-6
Reset Button
Power Button
See