Table of Contents
Advertisement
S
UPERSERVER 6023P-8R/6023P-8 User's Manual
Memory Support
The X5DP8-G2 only supports ECC registered DDR-266/200 (PC2100/1600)
memory. If you are using 533 MHz FSB processors, you must use DDR-266
SDRAM.
If you are using 400 MHz FSB processors, you may use either
DDR-266 or DDR-200 SDRAM. You should not mix DIMMs of different sizes
and speeds.
See Figures 5-5a and 5-5b for installing and removing memory modules.
Figure 5-5a.
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward
to free the DIMM from the slot.
Side View of DIMM Installation into Slot
Figure 5-5b.
Top View of DIMM Slot
5-8
Advertisement
Table of Contents
