Table of Contents
Advertisement
5-4
I/O Ports
The I/O ports are color coded in conformance with the PC 99 specification.
See Figure 5-4 below for the colors and locations of the various I/O ports.
Figure 5-4. X5DP8-G2 Rear Panel I/O Ports
Mouse
(Green)
Keyboard
USB Ports
(Purple)
5-5
Installing Memory
Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Also note that the
memory is interleaved to improve performance (see step 1).
DIMM Installation (See Figure 5-5)
1. Insert the desired number of DIMMs into the memory slots, starting with
Bank 1 (DIMM#1A, DIMM#1B). The memory scheme is interleaved so
you must install two modules at a time, beginning with Bank 1, then
Bank 2 and so on.
2. Insert each DIMM module into its slot. Pay attention to the notch along
the bottom of the module to prevent inserting the DIMM module incor-
rectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Chapter 5: Advanced Motherboard Setup
Parallel Port (Burgundy)
COM1 Port
(Turquoise)
CAUTION
5-7
VGA (Monitor) Port
GLAN1
(Blue)
GLAN2
Advertisement
Table of Contents
