Water Drainage - Midea MPPD40C User Manual

Water drainage

· During dehumidifying modes, remove the upper
drain plug from the back of the unit, install the drain
connector(5/8" universal female mender) with 3/4"
hose(locally purchased). For the models without
drain connector, just attach the drain hose to the
hole. Place the open end of the hose directly over the
drain area in your basement floor.
Remove the
upper drain
plug
Continuous
drain hose
√
MODEL A
· During heating pump mode, remove the lower drain
plug from the back of the unit, install the drain
connector (5/8" universal female mender) with 3/4"
hose(locally purchased). For the models without drain
connector, just attach the drain hose to the hole.
Place the open end of the Hose adaptor directly over
the drain area in your basement floor.
NOTE: Make sure the hose is secure so there are no
leaks. Direct the hose toward the drain, making sure
that there are no kinks that will stop the warter flowing.
Place the end of the hose into the drain and make sure
the end of the hose is down to let the water flow
smoothly.(See Figs with
with ). When the continuous drain hose is not used,
X
ensure that the corresponding drain plug and knob
are installed firmly to prevent leakage.
Remove the
lower drain
plug
Continuous
drain hose
drain hose
adaptor
√
MODEL A
√
drain
hose
adaptor
Remove the
upper drain
plug
Continuous
drain hose
√
MODEL B
. Do never let it up.(See Figs
√
Remove the
lower drain
plug
Continuous
drain hose
drain hose
adaptor
√
MODEL B
X
drain hose
adaptor
Press the
power
cord buckle
into the rear
cover.
· (For model A1)During heating pump mode,
remove the lower drain plug from the back of
the unit, install the drain connector(5/8"
universal female mender) with 3/4" hose
(locally purchased). Carefully move the unit to
a drain location, and let the water drain away.
Note: Make sure the drain hose is lower than the
bottom tray drain outlet.
Remove the
lower drain
plug
Continuous
drain hose
· When the water level of the bottom tray
reaches a predetermined level, the unit beeps
8 times, the digital display area shows "P1" .
At this time the air conditioning/
dehumidification process will immediately stop.
However, the fan motor will continue to
operate (this is normal). Carefully move the
unit to a drain location, remove the bottom
drain plug and let the water drain away.
Reinstall the bottom drain plug and restart the
machine until the "P1" symbol disappears. If
the error repeats, call for service.
NOTE: Be sure to reinstall the bottom drain
plug firmly to prevent leakage before using
the unit.
or
24
MODEL A1