Midea MPPD40C User Manual page 22

OPERATION INSTRUCTIONS
Swing - Function
1
Wireless - Function
(on some models)
2 Timer - Function
3 Mode - Function
Used to initiate the Auto swing feature. When the operation is ON,
press the SWING button can stop the louver at the desired angle.
Used to initiate the Wireless function. For the first time to use Wireless
function, press and hold the swing button for 3 seconds to initiate the
Wireless connection mode. The LED DISPLAY shows 'AP' to indicate
you can set Wireless connection. If connection(router) is successful
within 8 minutes, the unit will exit Wireless connection mode
automatically and the Wireless indicator illuminates. If connection is
failure within 8 minutes, the unit exits Wireless connection mode
automatically. After Wireless connection is successful, you can press
and hold SWING and DOWN (-) buttons at the same time for 3
seconds to turn o Wireless function and the LED DISPLAY shows 'OF'
for 3 seconds, press SWING and UP(+) buttons at the same time to turn
on Wireless function and the LED DISPLAY shows 'On' for 3 seconds.
NOTE: When you restart the Wireless function, it may take a period of
time to connect to the network automatically.
Used to initiate the AUTO ON start time and AUTO OFF stop time
program, in conjuction with the + & - buttons. The timer on/o
indicator light illuminates under the timer on/o settings.
· When the unit is on, press the Timer button will initiate the Auto-o
stop program, the TIMER OFF indicator light illuminates. Press the
UP or down button to select the desired time. Press the TIMER
button again within 5 seconds, the Auto-on start program is
initiated. And the TIMER ON indicator light illuminates. Press the
up or down button to select the desired Auto-on start time.
· When the unit is o , press the Timer button to initiate the Auto-on
start program, press it again within 5 seconds will initiate the
Auto-o stop program.
· Press or hold the UP or DOWN button to change the Auto time by
0.5 hour increments, up to 10 hours, then at 1 hour increments up to
24 hours. The
control will count down the time remaining until start.
· The system will automatically revert back to display the previous
temperature setting if there is no operation in a 5 seconds period.
· Turning the unit ON or OFF at any time or adjusting the timer
setting to 0.0 will cancel the Auto Start/Stop timer program.
Selects the appropriate operating mode. Each time you press the
button, a mode is selected in a sequence that goes from AUTO),
COOL, DRY, FAN and HEAT (cooling only models without). The
mode indicator light illuminates under the di erent mode settings.
DRY operation
· Press the "MODE" button until the "DRY" indicator light comes on.
· Under this mode, you cannot select a fan speed or adjust the
temperature. The fan motor operates at LOW speed.
· Keep windows and doors closed for the best dehumidifying e ect.
AUTO operation
· When you set the air conditioner in AUTO mode, it will automatically
select cooling, heating(cooling only models without), or fan only
operation depending on what temperature you have selected and
the room temperature.
· The air conditioner will control room temperature automatically
round the temperature point set by you.
· Under AUTO mode, you can not select the fan speed.
NOTE: Under AUTO mode, both the AUTO mode and the actual
operation mode indicator lights illuminate for some models.
FAN operation
· Press the "MODE" button until the"FAN " indicator light comes on.
· Press the "FAN SPEED" button to choose the fan speed. The
temperature can not be adjusted.
· Do not put the duct to window.
21
Description