Drainage Guide - Midea MAP10S1XWBL User Manual

Drainage guide

During dehumidifying modes, remove the upper drain plug from the back
of the unit, install the drain connector(5/8" universal female mender) with
3/4" hose(locally purchased). For the models without drain connector,
just attach the drain hose to the hole. Place the open end of the hose
directly over the drain area in your basement floor.
During heating pump mode,
remove the lower drain plug
from the back of the unit,
install the drain connector
(5/8" universal female mender)
with 3/4" hose(locally purchased).
For the models without drain
connector, just attach the drain
hose to the hole.
Place the open end of the Hose
adaptor directly over the drain
area in your basement floor.
NOTE
Make sure the hose is secure so there are no leaks. Direct the hose toward
the drain, making sure that there are no kinks that will stop the warter
flowing. Place the end of the hose into the drain and make sure the end of
the hose is down to let the water flow smoothly. Do never let the end of the
hose up. When the continuous drain hose is not used, ensure that the
corresponding drain plug and knob are installed firmly to prevent leakage.
During heating pump mode, carefully move the unit to a drain location,and let
the water drain away.
NOTE
Make sure the drain hose is lower than the bottom tray drain outlet.
When the water level of the bottom tray
reaches a predetermined level, the unit
beeps 8 times, the digital display area
shows "P1" . At this time the air
conditioning/dehumidification process
will immediately stop. However, the fan
motor will continue to operate
(this is normal). Carefully move the unit
to a drain location, remove the bottom
drain plug and let the water drain away.
Reinstall the bottom drain plug and
restart the machine until the "P1" symbol
disappears. If the error repeats, call for
service.
NOTE
Be sure to reinstall the bottom drain
plug firmly to prevent leakage before
usingthe unit.
√ √
drain hose
adaptor
Continuous
drain hose
23
Remove the
upper drain
plug
Continuous
drain hose
X
drain hose
adaptor
Press the power
cord buckle into
the rear cover.
Remove the
lower drain
plug
Continuous
drain hose