Midea MPPD40C User Manual page 23

Up and Down buttons
4
Fan - Function
Constant - Function
5
(on some models)
ION/Fresh feature
(on some models)
Sleep - Function
6
ECO - Function
(Opetional)
Power ON/OFF
7
LED Display
8
Used to adjust (increasing/decreasing) temperature settings in
1°C/1°F (or 2 °F) increments in a range of 17°C/62°F to 30°C/86°F
(or 88°F) or the TIMER setting in a range of 0~24hrs.
NOTE: The control is capable of displaying temperature in degrees
Fahrenheit or degrees Celsius. To convert from one to the other,
press and hold the Up and Down buttons at the same time for
3 seconds.
Control the fan speed. Press to select the fan speed in four steps-
LOW, MED, HIGH and AUTO. The fan speed indicator light illuminates
under di erent fan settings. When select AUTO fan speed, all the fan
indicator lights turn dark. On some models, when select AUTO fan
speed, all the fan indicator lights illumiante.
Press FAN button for 3 seconds to initiate ION/FRESH feature and
the ION/FRESH light illumiantes(if applicable), the LED DISPLAY
shows 'On' for 3 seconds for some units. The ion generatoris
energized and will help to purify the air inside. Press it for 3 seconds
again to stop the ION/FRESH feature and the ION/FRESH light turn
dark(if applicable), the LED DISPLAY shows 'OF' for 3 seconds for
some units.
Note: For some models, the fan speed can not be adjusted under
HEAT mode.
Used to initiate the SLEEP/ECO operation.
· Press this button, the selected temperature will increase(cooling) or
decrease(heating) by 1°C/2°F(or 1°F) 30 minutes. The temperature
will then increase (cooling) or decrease (heating) by another
1°C/2°F(or 1°F) after an additional 30 minutes. This new temperature
will be maintained for 7 hours before it returns to the originally
selected temperature. This ends the Sleep/Eco mode and the unit
will continue to operate as originally programmed.
NOTE: This feature is unavailabe under FAN or DRY mode.
Power switch on/o .
Shows the set temperature in °C or °F("°F" no display for some
models) and the Auto-timer settings. While on DRY and FAN modes,
it shows the room temperature.
Shows Error codes and protection code:
E1-Room temperature sensor error.
E2-Evaporator temperature sensor error.
E3-Condenser temperature sensor error (On some models).
E4-Display panel communication error.
EC-Refrigerant leakage detection malfunction (On some models).
P1-Bottom tray is full--Connect the drain hose and drain the collected
water away.If protection repeats,call for service.
Note: When one of the above malfunctions occurs, turn o the unit,
and check for any obstructions. Restart the unit, if the malfunction
is still present, turn o the unit and unplug the power cord. Contact
the manufacturer or its service agents or a similar qualified person
for service.
22
Description