Midea MPPD40C User Manual page 20

Type 2: Wall Installation(For some models)
NOTE
Cover the hole using the adaptor cap when not in use.
Step 1:
Cut a 125mm (4.9inches) hole into the wall
for the Wall Exhaust Adaptor B.
4-15/16inch
(125mm)
wall hole
The center of the hole in the wall should be
between 80cm(31 inches) and 140cm(55 inches)
from the ground.
INCORRECT
VENT CONTROL feature(for MODEL B)
max 120cm or 47 inch
min 30cm or 12 inch
CORRECT
Step 2:
Secure the Wall Exhaust Adaptor B to the wall using
the four Anchors and Screws provided in the kit.
Expansion
anchor 4*
Screws 4*
Wall Exhaust
Adaptor B
Adaptor cap
Step 3：
Connect the Exhaust Hose
Assembly(with Wall
Exhaust Adaptor A) to the
Wall Exhaust Adaptor B.
NOTE:
To ensure proper function, DO NOT overextend or bend
the hose. Make sure that there is no obstacle around the
air outlet of the exhaust hose (in the range of 500mm)
in order to the exhaust system works properly. All the
illustrations in this manual are for explanation purpose
only. Your air conditioner may be slightly di erent. The
actual shape shall prevail.
The Vent Control is located at the back of the air
conditioner. The OPEN position removes stale air from
the room and exhausts it to the outside. Fresh air is
drawn in through normal passages in the home. When
not need to circulate the room air, set Vent Control to
CLOSE position. This function is only applicable for
MODEL B.
19