Audio Insertion; After-Market Front Camera - r.LiNK RL4-UCON8-CP Manual

Video-inserter, compatible with jeep vehicles with uconnect smarttouch 8.4“ infotainment

Table of Contents

2.8.1. Audio-insertion

This interface is only able to insert video signals into the factory infotainment. If an AV-

source is connected, the audio insertion has to be done by the factory audio AUX input or an

FM-modulator. The inserted video-signal can be activated simultaneously to each audio-

mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,

additional electronic is necessary to switch the audio signals.

The red power supply output

a front camera. If Dip 1 is set to ON (black 8 dips), the power supply output gives

+12V (max 3A) when reverse gear is engaged incl. 10 seconds delay after reverse gear

is disengaged.

Note: In addition, a manual switch-over to the front camera input is possible via keypad

(short press) from any image mode. The power supply output gives +12V then, as well (if Dip

1 is set to ON and the front camera input is selected).

Attention: A long press of the external keypad push button will switch the interface to the

next source.

Version 24.09.2019

ACC/front cam out 12V (max 3A)

HW CANM(V98)/(V34)

can be used to power

RL4-UCON8-CP

Table of Contents