Starting A Cycle Wash; Changing The Program Mid-Cycle; Forget To Add A Dish - Kernau KDI 4872 Instruction Manual

10.2. Starting A Cycle Wash

• Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
• Pour in the detergent.
• Insert the plug into the socket. The power supply refer to last page "Product fiche".
Make sure that the water supply is turned on to full pressure.
• Open the door, Press the Power button.
• Choose a program, the response light will turn on. Then close the door,
the dishwasher will start its cycle.

10.3. Changing The Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have already
drained the wash water. If this is the case, the dishwasher needs to be reset and the
detergent dispenser must be refilled.
To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stop working,
you can open the door completely.
2. Press Program button more than three seconds the machine will be in stand by state.
3. You can change the program to the desired cycle setting.

10.4. Forget To Add A Dish

A forgotten dish can be added any time before the detergent dispenser opens.
If this is the case, follow the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. The dishwasher will start running again.
3 sec
EN
87