Functions Supported In Software Version 1.1 - Sony Trimaster BVM-L170 Operation Manual

Functions Supported in Software Version 1.1

The following new functions are supported for Version 1.1 of the BVM-L170.
Menu
• 3G/HD/SD-SDI Auto
• 3G-SDI
(in the 3G/HD/SD-SDI menu of the Format menu of
the Input Configuration menu)
Color Gamut
(in the Input Configuration menu)
Marker Preset
(in the Input Configuration menu)
Aspect Correction
(in the Native Scan Mode menu of the Display
Setting menu)
Audio Level Meter
(in the Function Switch menu of the Display
Function menu)
(in the On Screen Set menu of the System
Configuration menu)
ALM Hold Reset
(in the Function Switch menu of the Display
Function menu)
Time Code
(in the Function Switch menu of the Display
Function menu)
(in the On Screen Set menu of the System
Configuration menu)
• Auto 1
• Auto 2
(in the Type menu of the Closed Caption menu of
the On Screen Set menu of the System
Configuration menu)
SDI Payload ID Status
(in the Status menu)
Supported function
The BKM-250TG (optional) is available.
3G-SDI, HD-SDI, Dual Link HD-SDI and SD-SDI signals
can be input by installing the BKM-250TG.
The color gamut to be used (color space and gamma) is
set for each channel.
The marker preset data are set for each channel.
When the input signal system is the SD signal of
720 × 576 or 1440 × 576 and Native Scan Mode is set to
Aspect Correction and the aspect ratio is 16:9, no
display area of the left and right sides over the H size
(1920) is displayed by sliding the picture with the
PHASE knob of the controller.
(In version 1.0 of the software, you can display no
display area only when the input signal system is
2048 × 1080 and the native scan mode is selected.)
The audio level of the embedded audio signals
superimposed on the SDI signals is displayed by
installing the BKM-250TG (optional).
The time code superimposed on the SDI signals is
displayed by installing the BKM-250TG (optional).
Auto 1 and Auto 2 can be selected for the closed
caption type (when the BKM-244CC (optional) is
installed).
The information on the Payload ID data superimposed
on the SDI signal input from the BKM-250TG (optional)
and current signal status of the monitor are displayed.
Reference page
50
55
55
60, 89
71, 76, 96
71
71, 76, 97
76
82
Functions Supported in Software Version 1.1
9