Sony Trimaster BVM-L170 Operation Manual page 57

Menu
Film Cadence
Copy From
Other CH
Other Monitor
Monitor ID
Memory Stick
Function and operation ([
Sets the film cadence mode.
This menu is not selectable when Format is set to DVI Computer.
The progressive conversion signal is displayed according to the setting.
[Off]: The progressive conversion signal is not displayed in film cadence mode.
2-2: The progressive conversion signal is displayed when the interlace signal of 2-2 pull-
down processing is input
2-3: The progressive conversion signal is displayed when the interlace signal of 2-3 pull-
down processing is input
2-3-3-2: The progressive conversion signal is displayed when the interlace signal of 2-3-
3-2 pull-down processing is input
Notes
• When the 50i interlace signal is input, the mode is automatically set to 2-2, even when 2-3
or 2-3-3-2 is selected.
• The signal is not displayed in film cadence mode when 1080i interlace signal is input and
1080PsF is selected in the 1080I/PsF menu. Set to 1080I.
• As the signal is displayed in film cadence mode by cadence sequence detection based on
the pattern of the input signal, the signal may not be displayed correctly, because of the
pattern of the input signal.
• The signal is not displayed in film cadence mode in the following cases:
– When Side by Side is set to On
– When Wipe is set to On
– When Butterfly is set to On
– When Blending is set to On
Copies signal setting data from other channel.
Note
You cannot copy the User LUT data.
Copies other data in this monitor.
When the item is selected, you can designate the channel to be copied.
Copies data from other monitor.
Enters the ID number of the source monitor.
When the NETWORK switch is set to PEER TO PEER, this is not selectable.
When the item is selected, you can designate the source monitor.
When the ID number is entered, you can designate the channel to be copied.
Copies data in the "Memory Stick".
When the item is selected, the file names in the source "Memory Stick" are displayed.
When the file is selected, you can enter the channel number in the selected file.
]: factory setting)
57
Input Configuration Menu