Sony Trimaster BVM-L170 Operation Manual page 60

Menu
Native Scan Mode
Aperture Value
NTSC Comb Filter
Filter Switch
Peak White Control
60
Display Setting Menu
Function and operation ([
Sets the native scan mode.
[Aspect Correction]: Displaying an SD signal of non-square pixels (the number of H
pixels of the signal system is 720 or 1440) or a 640 × 480 SD signal of DVI video/HDMI
video by scaling processing of doubling for the V direction and correct aspect ratio for the
H direction and also optimizing and displaying a picture by modifying the aperture
coefficient value, filter coefficient value, etc.
×1: Input signal display without conversion
×2: Input signal display doubled
For selecting Aspect Correction, ×1 or ×2, see "Picture Display Size" on page 115.
Notes
• When an HD signal, DVI computer signal or the computer signal of HDMI is input, the
signal is displayed in ×1 mode, even if the mode is set to Aspect Correction or ×2.
• When an SD signal from the BKM-229X is input and the number of the H pixels of the
signal system is 1440, the signal is displayed in ×2 mode, even if the mode is set to ×1.
• When you select Aspect Correction and set Native Scan to On for SD signal input, Aperture
is set to On (factory setting).
Sets the aperture modification value.
Sets to 000 to 200.
[090] (when the signal is displayed in Aspect Correction mode of the native display), [000]
(when the signal is displayed in mode other than Aspect Correction of the native display)
Sets the type of NTSC filter.
You can select from [3Lines] or 3D.
When the BKM-227W is installed, you can select the item.
Sets whether or not to turn on the Y/C separation filter ([Off] or On) when the picture is set to
monochrome mode.
When the BKM-227W is installed, you can select the item.
When the brightness is increased, using the brightness adjustment, the picture may be
clipped, because of the dynamic range of the circuit. Sets whether or not to control the signal
gain automatically according to the setting value of the brightness, to prevent such clipping
(Off or [On]).
Note
Peak white control does not function with XYZ signals.
]: factory setting)