Table of Contents
Advertisement
1
Select the channel (CH1 to CH30) to be assigned by
pressing the numeric button of the controller.
To assign to a channel number from 1 to 9, press the
appropriate one-digit channel number on the numeric
keypad.
To assign to a channel number from 10 to 30, press the
0 button, then press the appropriate two-digit channel
number.
2
Set the input signal for the selected channel in Input
Configuration menu (page 50).
The required setting is different due to the input signal
or picture quality to be displayed.
For details of the setting, see the Input Configuration
menu (page 50).
Setting the Display Mode of the
Picture
Set the display mode condition of the input signal to
display on the screen. The setting items are following.
• Setting Matrix/Gamma (transmission matrix and
transmission gamma)
• Selecting the color gamut (color space and gamma)
1
Set Matrix/Gamma in the Matrix/Gamma menu (page
53) of the Input Configuration menu.
2
Select the color gamut (color space and gamma) in the
Emulation menu (page 55) of the Color Gamut menu
of the Input Configuration menu.
1
Adjusting
Before adjusting
The monitor must be warmed up sufficiently.
To perform stable color reproduction, turn on the power of
the monitor, display the white signal and leave it in this
state for more than 30 minutes.
About monitor adjustment
The monitor is used as a measuring instrument and is
required to faithfully reproduce the input signal. To
measure the signal accurately, the monitor must be
calibrated correctly using a reference signal.
To calibrate, adjust the following items in sequence.
1 Chroma/phase adjustment
You can save the adjustment value in Preset1 to
Preset5 and Preset (D-Cine). The data of Preset1 to
Preset5 or Preset (D-Cine) is set to the channel in the
Picture Preset menu (page 53) of the Input
Configuration menu.
Adjust the picture automatically with the auto chroma/
phase/matrix function for every signal format and
signal system to display the composite signal or Y/C
signal from the BKM-227W, or analog component
signal or analog RGB signal from the BKM-229X. If
the picture is not adjusted, the picture may not be
displayed correctly.
2 Color Temperature (white balance) adjustment
You can adjust the data set to the channel in the Color
Temp menu (page 53) of the Input Configuration
menu.
You can adjust D93, D65, D61, D56, D-Cine or User1
to User5 except for the XYZ format signal and D-Cine
XYZ or User XYZ1 to User XYZ5 for the XYZ format
signal.
3 Brightness/Contrast adjustment
You can save the adjustment value in Preset1 to
Preset5 and Preset (D-Cine). The data of Preset1 to
Preset5 or Preset (D-Cine) is set to the channel in the
Picture Preset menu (page 53) of the Input
Configuration menu.
Chroma/Phase Adjustment
Automatic adjustment (with auto chroma/phase/matrix
function) is required for each signal format, signal system
and matrix to display the composite or Y/C signal from the
BKM-227W, or the analog component or analog RGB
signal from the BKM-229X.
As you can automatically adjust the chroma, phase, matrix
and also 100% (white) and 0% (black) levels of the monitor
to the same as those of the reference signal by performing
29
Adjusting
Advertisement
Table of Contents
