Turning On The Power; Connecting To Power; Turning On The Monitor - Sony Trimaster BVM-L170 Operation Manual

Turning on the Power

Connecting to Power

You can operate the monitor with AC or DC power supply.
To connect the AC power cord
1
Plug the AC power cord into the AC IN connector on
the rear panel. Then, attach the AC plug holder
(supplied) to the AC power cord.
AC plug holder
(supplied)
Attach the AC plug holder to the AC power cord, and connect
the cord to the AC IN connector so that the cord does not come
loose.
2
Slide the AC plug holder over the cord until it locks.
To disconnect the AC power cord
Pull out the AC plug holder while pressing the lock levers.
To connect the DC power supply
Connect the DC power supply to the DC IN 24 - 28V
connector.
When the AC power cord and DC power supply are
connected, the AC power supply is given preference to
over the DC power supply. To use the DC power supply,
disconnect the AC power cord.
AC power cord
(supplied)

Turning on the Monitor

Press the MAIN POWER switch on the rear panel to turn
on the power.
When you turn on the monitor for the first time after
purchasing it, the Select Area screen is displayed. Select
the area where you intend to use this monitor.
For selecting the area, see page 26.
The warm-up time is more than 30 minutes, approximately.
When the monitor is in standby mode
As the OPERATE lamp lights in red in standby mode,
press the MONITOR I/1 switch of the controller.
The OPERATE lamp lights in green and the monitor enters
operation mode.
25
Turning on the Power