Assigning The Input Signal To The Channel; Setting The Display Mode Of The Picture - Sony BVM-F250 Operation Manual

The monitor of the designated group is connected
remotely.
The group ID number is displayed on all connected
monitors when the button is held pressed.
ALL button: Selects all connection mode.
All monitors are connected remotely.
The lamp corresponding the pressed button flashes and
lights after recognizing the monitor.
2
Select the monitor ID number for the single connection
mode or group ID number for the group connection
mode by pressing the UP/DOWN or numeric button.
Up to 99 is entered as the monitor ID or group ID
number.
3
Press the ENTER or Ent button to confirm the setting.
The monitor ID number, group ID number or ALL is
displayed in the display window.
Notes
• When the monitor with no assigned monitor ID number
or group ID number is selected, the setting is not changed
and the previous connection status is maintained.
• When there are monitors with the same ID number, the
monitor with the lower IP address is selected.
• Even if a different monitor ID number is set to the
monitors, when the same IP address is set to another
monitor, the monitor cannot be connected to the network.
Assigning the Input Signal to the
Channel
When you assign the input signal to the channel, you can
select the channel and change the input signal by pressing
the numeric button. The input signal is assigned to one of
channels 1 to 30.
1
1
Select the channel (CH1 to CH30) to be assigned by
pressing the numeric button of the controller.
To assign to a channel number from 1 to 9, press the
appropriate one-digit channel number on the numeric
keypad.
To assign to a channel number from 10 to 30, press the
0 button, then press the appropriate two-digit channel
number.
2
Set the input signal for the selected channel in Channel
Configuration menu (page 56).
The required setting is different due to the input signal
or picture quality to be displayed.
Setting the Display Mode of the
Picture
Set the display mode condition of the input signal to
display on the screen. The setting items are following.
• Setting Matrix (transmission matrix)
• Selecting the color profile (color space and gamma)
1
Set Matrix in the Matrix menu (page 59) of the
Channel Configuration menu.
2
Select the color profile (color space and gamma) in the
Color Profile menu (page 59) of the Channel
Configuration menu.
37
Settings