Table of Contents
Advertisement
Display window
3
2
1
Press the corresponding button to select the connection
mode.
SINGLE button: Selects single connection mode.
The designated monitor is connected remotely.
The monitor ID number is displayed on all connected
monitors when the button is held pressed.
GROUP button: Selects group connection mode.
The monitor of the designated group is connected
remotely.
The group ID number is displayed on all connected
monitors when the button is held pressed.
ALL button: Selects all connection mode.
All monitors are connected remotely.
The lamp corresponding the pressed button flashes and
lights after recognizing the monitor.
2
Select the monitor ID number for the single connection
mode or group ID number for the group connection
mode by pressing the UP/DOWN or numeric button.
Up to 99 is entered as the monitor ID or group ID
number.
3
Press the ENTER or Ent button to confirm the setting.
The monitor ID number, group ID number or ALL is
displayed in the display window.
Notes
• When the monitor with no assigned monitor ID number
or group ID number is selected, the setting is not changed
and the previous connection status is maintained.
• When there are monitors with the same ID number, the
monitor with the lower IP address is selected.
• Even if a different monitor ID number is set to the
monitors, when the same IP address is set to another
monitor, the monitor cannot be connected to the network.
30
Settings
Lamp
1
2
3
Assigning the Input Signal to the
Channel
When you assign the input signal to the channel, you can
select the channel and change the input signal by pressing
the numeric button. The input signal is assigned to one of
channels 1 to 30.
1
Select the channel (CH1 to CH30) to be assigned by
pressing the numeric button of the controller.
To assign to a channel number from 1 to 9, press the
appropriate one-digit channel number on the numeric
keypad.
To assign to a channel number from 10 to 30, press the
0 button, then press the appropriate two-digit channel
number.
2
Set the input signal for the selected channel in Input
Configuration menu (page 50).
The required setting is different due to the input signal
or picture quality to be displayed.
For details of the setting, see the Input Configuration
menu (page 50).
Setting the Display Mode of the
Picture
Set the display mode condition of the input signal to
display on the screen. The setting items are following.
• Setting Matrix/Gamma (transmission matrix and
transmission gamma)
• Selecting the color gamut (color space and gamma)
1
Set Matrix/Gamma in the Matrix/Gamma menu (page
53) of the Input Configuration menu.
2
Select the color gamut (color space and gamma) in the
Emulation menu (page 54) of the Color Gamut menu
of the Input Configuration menu.
1
Advertisement
Table of Contents
