Hyundai HHC2GNK User Manual page 30

Loading and Operation
Warning: Always disconnect the tool from the compressed air source
before loading fasteners. Always point the tool away from yourself and
others. Make sure that you are not holding the tool with the trigger
depressed while loading. Only use impact sockets that are specifically
designed for use with impact wrench.
1. Insert a strip of fasteners into the magazine keeping it pointed
down. The fasteners should be inserted flush against the side of
the magazine.
2. Slide the magazine cover against the nails until it clicks closed.
3. Never operate the tool unless safety nose is in contact with
the work piece. Do not operate the tool without fasteners or
damage to the tool may occur.
4. Never fire fasteners into the air as this can cause an injury to
the operator or others and damage to the tool may occur.
5. The air tool is equipped with a safety nose mechanism that
disables the tool unless pressure is applied to the nose while
against the work piece. Hold the gun body firmly and press the
safety nose against the work piece where the fastener is to
be applied. Pull the trigger to drive the fastener into the work
piece.
30