Chapter 4 - Start-Up & Operation - Hyundai HHC2GNK User Manual

Chapter 4 - Start-Up & Operation
Initial Inspection
All air compressors have been inspected carefully before leaving
the factory. It is possible that poor handling during transport caused
damage to the compressor. Fully inspect the compressor before use.
1. Inspect the entire unit for any concealed and/or visible damage.
2. Make sure any damaged parts are replaced and any mechanical
issues are repaired by a qualified and licensed/certified
mechanic.
Pre-Start Checklist
1. Make sure the power switch is in the OFF position.
2. Make sure the tank is fully drained.
3. Make sure the tank pressure gauge reads 0 PSI.
4. Make sure the drain valves are closed.
5. Make sure all covers and safety guards are properly installed
and in place.
Initial Break-In Procedure
The following instructions should be followed before the first time the
compressor is operated in order to optimize the life of the compressor
and to help prevent any damage to the unit.
1. Make sure the regulator knob is turned counter-clockwise.
2. Plug the power cord into a properly grounded power outlet.
3. Open the drain valve in order to allow air to escape and
prevent pressure from building up inside the tank (during initial
break-in).
15