Table of Contents
Advertisement
Chapter 1 General Description
4.5.2
STATUS LED 1, 2 (1-
While hardware is operating normally, STATUS LED 1 lights green. STATUS LED 2 is off.
STATUS LED 1 is off or STATUS LED 2 lights/flashes amber if there is a hardware failure.
The following table lists STATUS LED patterns, their description and action. If the LED indication does not
change even if the action below is performed, contact your sales representative.
STATUS LED 1, 2 pattern
STATUS LED 1
STATUS LED 2
On (green)
Off
On (green)
On (amber)
Blinking (green) Off
Off
Off
Off
On (amber)
Off
Blinking (amber)
-2)
Tips
If NEC ESMPRO is installed, you can view error logs to check the causes of
failures.
Description
The server is operating normally.
Initialization of BMC is in progress.
Memory is in a degraded state
A correctable memory error has often
occurred.
Operating while CPU error is detected.
In redundant power configuration, power is
not supplied to either of power unit.
The power is off.
POST is in progress.
Watchdog timer expired.
Memory dump is being requested.
Note: It remains green if the dump is caused
by software.
A temperature alarm was detected.
A CPU error occurred.
A PCI system error occurred
A PCI parity error occurred
A PCI bus error occurred.
A voltage alarm was detected.
Sensor error was detected.
A CPU temperature alarm was detected.
An error occurred on Intel Node Manager
(one of the features of EXPRESSSCOPE
Engine 3).
Power Supply Unit is failing (in power
redundant configuration).
A fan alarm was detected.
A temperature warning was detected.
A voltage warning was detected
One or more hard disk drives are failing
(Only RAID system configuration).
Express5800/T110i-S User's Guide
4. Names and Functions of Parts
Action
–
Wait until initialization completes.
Find the device in degraded state by using
BIOS Setup Utility (SETUP), and replace it as
soon as possible.
Turn on the server.
Wait for a while. STATUS LED will turn green
after POST completes.
Turn the power off and then turn it on.
If POST screen displays any error message,
take notes of the message, and contact your
sales representative.
Wait until the memory dump is completed.
Check the internal fan for dusts. Also check if
the fan unit is properly connected.
Turn the power off and then turn it on.
If POST displays any error message, take
notes of the message, and contact your sales
representative.
Contact your sales representative.
Contact your sales representative.
Check if the internal fan cable is properly
connected.
Check the internal fan for dusts. Also check if
the fan unit is properly connected.
Contact your sales representative.
27
Advertisement
Table of Contents
