Table of Contents
Advertisement
Getting Started
Carefully remove your radio from the box. You may
wish to store the packaging for future use.
What you can find inside of your package
Main unit
Power adapter
Instruction manual
Positioning your Radio
Place your radio on a flat / stable surface that is not
subject to vibrations.
Avoid the following locations:
Where the radio will be exposed to direct
sunlight.
Where the radio will be close to heat radiating
sources.
Where the humidity is high and ventilation is
poor.
Where it is dusty.
Where it is damp or there is a possibility of
water dripping or splashing onto unit.
Adjusting the Antenna
The antenna should be extended to ensure you
receive the best reception possible in both DAB and
FM radio modes. It may be necessary to alter the
position of the radio and /or antenna to achieve the
best signal.
Using Headphones
You will require headphones fitted with a 3.5 mm
diameter stereo plug. The Headphone socket is
located on the rear of the unit. Headphones are not
supplied with this digital radio.
Turn down the volume before connecting
headphones. Slowly raise the volume with the
headphones on until you reach your desired level.
Caution: long-term exposure to loud music may
cause hearing damage. It is best to avoid extreme
volume when using headphones, especially for
extended periods of time.
Turning the unit on/off
Connect the plug at the end of power adapter cable
to the DC IN socket on the rear of the unit. Then
insert the power adapter into the mains socket.
Press POWER/STANDBY button to switch radio go
to standby.
Press POWER/STANDBY button a second time to
switch radio on.
Press and hold POWER/STANDBY button to switch
radio off. To switch the unit off completely, unplug the
power adapter from the mains socket.
Volume Control
Press VOLUME+ or VOLUME- button to increase or
decrease volume.
Digital Radio Mode (
When you turn on the radio it will automatically
search and store all the available stations. You
should conduct an additional Full Scan to ensure all
stations are picked up and stored. It is also
recommended every few months to run a new scan
to pick up any new DAB/DAB+ that may have begun
broadcasting after purchasing your DAB radio.
1.
For initial use, your radio will conduct a full scan
and store stations list in memory.
2.
Once the scanning is completed, the
DAB/DAB+ stations will be displayed in
alphanumeric order. The first station in the list
will be selected to broadcast.
Note: the DAB/DAB+ stations will be
displayed and stored in alphanumeric order.
If no DAB/DAB+ signal is found, it may be
necessary for you to relocate your radio.
)
DAB Mode
5
Advertisement
Table of Contents
