Advertisement
Installing the Access Point on the Wall Mounting Bracket
1.
Align the bottom of the access point over the bracket so that the two screws on the
bottom of the device fit into the bracket keyholes.
2.
Slide the access point forward until its screws are seated in the bracket keyhole slots
and the bracket thumbscrew is aligned with the screw hole on the front panel.
3.
Tighten the thumbscrew to secure the access point to the wall mounting bracket.
4.
Place the Ethernet cable(s) and power cable (if any) along the cable guides inside of
the top cover in the cable hiding space.
Installing an Anti-theft Device
Installation of an anti-theft cable/lock is optional.
Note
Anti-theft devices are not available from Allied Telesis.
1.
Follow the instructions provided with the vendor's anti-theft device for the
installation.
Kensington
Lock Port
Starting the Initial Management Session
The access point firmware includes a DHCP client. The default setting for the client is
enabled. When you power on the access point for the first time, it queries the subnet on the
LAN port for a DHCP server. If a DHCP server responds to its query, the unit uses the IP
address the server assigns to it.
If there is no DHCP server, the access point uses the default IP address:
TQ6702 GEN2 and TQm6702 GEN2: 192.168.1.230
TQ6702 GEN2-R: 192.168.1.1
To start the initial management session, perform the following procedure:
1.
Start the web browser on your management workstation.
2.
Enter the IP address of the wireless access point in the URL field of the web
browser. The address is one of the following:
If your network does not have a DHCP server, enter the default IP address.
If your network has a DHCP server, enter the IP address the DHCP server
assigned to the access point.
See the following screen as an example.
3.
Enter "manager" for the username and "friend" for the password. The username and
password are case-sensitive.
7
Starting a Local Management Session for TQ6702 GEN2-R
Note
This section is for the TQ6702 GEN2-R model only.
The TQ6702 GEN2-R device can be configured through a local session from the Console
port in addition to the Web User Interface.
To start a local management session, perform the following procedure:
1.
Connect the RJ-45 end of the management cable to the Console port on the TQ6702
GEN2-R device.
2.
Connect the other end of the cable to an RS-232 port on a terminal or personal
computer with a terminal emulation program.
3.
Configure a terminal or terminal emulation program as follows:
Baud rate: 115200 bps
Data bits: 8
Parity: None
Stop bit: 1
Flow controller: None
Emulation: VT100
Note
The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal
emulator program.
4.
Press Enter. You are prompted for a user name and password.
5.
Enter "manager" for the username and "friend" for the password. The username and
password are case-sensitive.
The local management session starts.
awplus>
The AlliedWare™ Plus operating system is installed on the TQ6702 GEN2-R device.
Setting the Country Setting
The non-US model of this product has a country code setting that must be set during the
initial management session of the unit. The setting ensures that the unit operates in
compliance with the laws and regulations of your country or region.
The country code for the US model is preset and cannot be changed. Per FCC
regulations, the country code setting for all WiFi products marketed in the US must be
fixed to US operational channels only.
8
9
Advertisement
