Removing Glass - Faber e-MatriX 800-RD Manual

Manual e-MatriX 800-RD/ST (LL)
--------------------------------------------------------------------------------------------------------------------------------------
4.4.2 Water connection
This appliance is equipped with the following overflow protections:
o Electromechanical valve in the Control box which is sent by an overflow sensor in the
water tank.
o Absorption valve in the Engine that kicks in when the water sump has an
unexpectedly overflow see fig. 5.0-K.

Connect all parts according flow diagram see fig. 5.0.
A = mains water
B = ½ or ¾" connector
C = ¼" 1m pipe
D = ball valve
E = to be cut from ¼" 1m pipe

Place the water filters at an accessible location in correct alignment, there's a "flow"
direction marking on both filters and Control box. See fig. 4.0.
!! Carry out a performance test see Chapter 9 and check all connections for water leakage before
placing the fuel bed and front glass.
4.5 Build-in structure

The e-MatriX needs a minimum ventilation of 50cm² above and 210cm² underneath the fire.

The construction may not rest on the fire.

The e-MatriX needs a minimum free space of 50mm above the fire.

5 Removing glass

5.1 Front glasses e-MatriX-RD
5.1.1 Front glass (see fig. 1.1a, provide service from this side)

Rotate the glass clamp clockwise. See fig. 2.0a and 2.0b.

Place the suction cups and remove the glass. See fig. 2.0c.
5.1.2 Second front glass
For cleaning only it's not necessary to remove this glass.

Place the suction cups and remove the glass. See fig. 2.2.
For replacing the front glass repeat the steps in reverse order.
5.2 Front glasses e-MatriX-ST
5.2.1 Front glass (see fig. 1.1b, provide service from this side)

Remove the cover strip. See fig. 2.3a, b and c.

Rotate the glass clamp clockwise. See fig. 2.3d and 2.3e.

Place the suction cups and remove the glass. See fig. 2.3f.
12 < < < <
F = mesh filter
G = in-line filter
H = control box
I = ¼" 1,5m pipe
J = e-MatriX engine
1 = safety clips (11x)
2 = in-line filter brackets (2x)
3 = elbows (4x)