Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 1 General 1.1 Introduction Only have the fire installed by a qualified installer according to the water and electric safety regulations. Read this installation manual properly. 1.2 Check Before installation, check the fire for transport damage and report immediately to your supplier.
Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 4 Installation instructions 4.1 Preparing the fire Ensure that all packing items are removed. Remove the transport screw on the front see fig. 1.0. Remove the front glass and store it at a safe place see Chapter 5.
Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 4.4 Build-in structure The e-MatriX needs a minimum ventilation of 50cm² above and 210cm² underneath the fire. The construction may not rest on the fire. The e-MatriX needs a minimum free space of 50mm above the fire.
Page 11
Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 8 Using the fire 8.1 Manual control - behind access door (see fig. 4.0) A = main switch 1 = ON/OFF 2 = pairing 3 = only for maintenance (service engineer) 4 = reduce flame 5 = increase flame...
Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 9 Performance test First time water fill, see Chapter 8.3. Check all connections for water leakage. Check if the fan, mounted at the top inside the fire, is running. Check if the remote control is functioning at the desired distance (max. 8m) o If needed, move the receiver to a different position in- or outside the construction (see fig.
Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 10.1.2 Cleaning air filter Gently slide the air filter upwards out of its plastic holder see fig. 8.0. Gently rinse with water in the sink and dry with fabric towel before returning. Replace the filter making sure that the coarse black filter is facing the front of the fire.
Manual e-MatriX 800 -------------------------------------------------------------------------------------------------------------------------------------- 12 Trouble shooting Symptom Cause Action The flame effect will not start. Mains plug is not plugged in. Check plug is connected to wall socket correctly. Low water level. See Chapter 8.3. The transducers) are not connected Check that the connector(s) is properly.
Need help?
Do you have a question about the e-MatriX 800 and is the answer not in the manual?
Questions and answers