Table of Contents
Advertisement
Manual e-MatriX 800-RD/ST (LL)
--------------------------------------------------------------------------------------------------------------------------------------
11 Technical data
Watts
Batteries remote
Water consumption
Inlet water pressure
Water connection
12 Trouble shooting
Symptom
The flame effect will not start.
e-MatriX will not start or stopped
working and the LED's continuously
to blink twice.
e-MatriX will not operate, the LED's
continuously to blink once every
eight seconds.
e-MatriX will not operate, the LED's
continuously to blink four times.
The flame effect is too low on the
highest setting.
The flame effect is too high and
there is too much smoke.
Remote is not working.
17 <
<
<
<
W
250
Volts
V
230-240
V
(2x) 1,5 AA
l/h
0,15
Bar
0,5-8
Inch
½ or ¾
Cause
Mains plug is not plugged in.
Low water level.
The transducers) are not connected
properly.
Low water level.
The absorption valve is activated
Water level too high.
Water filling time is too long.
The transducers and/or air filter are
dirty.
The extract fan doesn't work
anymore.
Low batteries.
Remote isn't paired to receiver.
Distance to fire too big
Action
Check plug is connected to wall
socket correctly.
See Chapter 8.3.
Check that the connector(s) is
inserted correctly see fig. 7.1.
See Chapter 8.3.
Switch the mains switch of the
Control box to the OFF position.
Check all connections on water
leakage.
Check that the ball valves are open.
See Chapter 10.2.
Check the electromechanical valve
in the Control box.
Switch the mains switch of the
Control box to the OFF position and
heck all connections on water
leakage.
Close the ball valves and check the
mesh filter (see fig. 5.0-F), by
unscrewing the base of it to see that
it is not clogged with dirt and debris.
Call for maintenance.
Check if the fan, mounted at the top
inside the fire, is running.
Place new batteries.
See Chapter 8.2.1.
See Chapter 9 (remote control).
Advertisement
Table of Contents
