Removing The Glass; Placing The Decorative Material - Faber Fyn 450 Installation Manual

L

5 Removing the glass


Remove the cover strips on the left and right hand side (see fig. 2.1).

Remove the glass clips, by using a screwdriver (see fig. 2.2).

Place the suction discs onto the glass (see fig. 1.6).

Slide the glass upwards so that the bottom edge is released. Now gradually
move the bottom edge of the glass forwards and lower the glass (see fig. 2.3).
To replace the glass repeat the process in reverse order.
Remove all fingerprints from the glass, these will be burned into it once the appliance is
used.

6 Placing the decorative material

It is not allowed to add different or more materials to the combustion chamber.
Always keep the pilot burner free from decorative material!
Do not toss all the decorative material onto the burner all at once, as the very fine dust
may block the holes in the burner.
6.1 Imitation logs

Spread the vermiculate preferably by hand over the tube burners. The surface of
the pebbles may be very slightly elevated from the burner plate but it should be
level throughout the entire length.

Place the imitation logs according to instructions. (see fig. 3.1 or the instruction
card).

It is optional whether you apply chips to the combustion chamber or not. Prevent
chips from covering the burner, this has a negative effect on the fire image.

Start the pilot en main burner, according to the instructions in the user's manual.
Assess whether the flame distribution is correct.

Place the glass and check the flame picture into the appliance.
6.2 Pebbles

Place the pebbles over the burner and the bottom. Spread the pebbles evenly to a
double layer. The surface of the pebbles may be very slightly higher than the
burner tube (see fig. 3.2 or the instruction card).

Place the glass and check the flame picture into the appliance.
7 < < < <