Using WPS to Connect to a Network
If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to
connect your product to the network.
1. Press the
2. Select the
3. Select Router and press the OK button.
4. Select Change Settings and press the OK button, if necessary.
5. Select Push Button Setup (WPS) and press the OK button.
6. Follow the instructions on the LCD screen to complete WPS setup.
7. Press the
You see the
your computer or device, and then print. If you are printing from a computer, make sure you installed
the network software as described on the Start Here sheet.
Note: If you don't see the
Parent topic:
Printing a Network Status Sheet
You can print a network status sheet to help you determine the causes of any problems you may have
using your product on a network.
1. Press the
2. Select Settings > General Settings > Network Settings > Network Status > Print Status Sheet.
3. Select Print.
Examine the settings shown on the network status sheet to diagnose any problems you have.
Parent topic:
Printing a Network Connection Report
You can print a network connection report to view solutions to any problems you may have using your
product on a network.
home button, if necessary.
icon and press the OK button.
home button to exit.
icon on the LCD screen and should be able to connect to your product directly from
icon, repeat these steps to try again.
Wi-Fi Protected Setup (WPS)
home button, if necessary.
Wi-Fi or Wired Networking
54