Table of Contents
Advertisement
Use:
Use ICC (Immersion Circulator Compact) for heating and
circulating fluids�
Intended Use: Tabletop device
Range of use:
Indoor environments similar to that a laboratory of research,
teaching, trade or industry�
Unpacking:
- Please unpack the device carefully
- In the case of any damage a detailed report must be sent
immediately (post, rail or forwarder)�
Transport safety
NOTICE
Remove the transport protection un-
der the
When you operate the device in water bath with temperature
higher than 60°C do not switch off the device before the tem-
perature is below 60°C� Water steam could enter into the
housing and cause damage�
Starting from software version 1�30 a function is included
which will let run the internal fan to avoid this effect even if
the device is switched to standby mode (by pressing the On/
Off button (A))�
Setting up:
- Securely fix the immersion circulator on the bath�
- Place the device on an even, stable, clean, nonslip, dry
and fireproof surface�
- Keep at least 20 cm of open space at the front and rear
side�
- When a plastic bath is used, please ensure that the heater
does not contact the bath�
- The place for installation should be large enough and pro-
vide sufficient air ventilation to ensure the room does not
warm up excessively because of the heat from device
radiates to the environment�
- Do not set up the device in the immediate vicinity of heat
sources and do not expose to sun light�
Intended use
Unpacking
(4)�
buoyage
Useful information
Preparations
The safety of the user cannot be guaranteed:
- If the device is operated with accessories that are not sup-
plied or recommended by the IKA�
- If the device is operated improperly or in contrary to the
IKA specifications�
- If the device or the printed circuit board are modified by
third parties�
Delivery scope:
- ICC baisc
- Mains cables
- USB 2�0 cable (A–micro B)
- Screwdriver (use for safety circuit)
- User guide
- Warranty card�
Do not disconnect the power cord or switch the device off by
pressing the power switch (2)� Alternatively remove the ICC
device out of the bath�
Update the firmware to enable this feature (see section "Inter-
face and output")�
Note: with an older software version let the pump run until
the water temperature is below 60°C�
Filling and draining:
- Connect the mains plug and turn on the device with
mains switch (2)�
- The low level warning message appear on the display�
- Fill fluid to the bath�
Note: Pay attention to the fluid level information on the
display:
For draining, please refer to the bath operating instructions�
Low Level
High Level
7
Advertisement
Table of Contents
