Intended Use; Use; Range Of Use; Unpacking - IKA RC 2 GREEN basic Operating Instructions Manual

Hide thumbs Also See for RC 2 GREEN basic:
Table of Contents

Advertisement

Use:

Use RC 2 GREEN (Refrigerated Circulators) for tempering
and circulating fluids�
Intended Use: Tabletop device

Range of use:

Indoor environments similar to that a laboratory of research,
teaching, trade or industry�

Unpacking:

- Unpack the device carefully�
- Any damage should be notified immediately to the ship-
ping agent (post office, railway network or logistics com-
pany)�
Setting up:
- Place the unit on an even, stable, clean, nonslip, dry and
fireproof surface�
- Keep at least 20 cm of open space on the front and rear side�
- The place for installation should be large enough and pro-
vide sufficient air ventilation to ensure the room does not
warm up excessively because of the heat from device
radiates to the environment�
- Do not set up the device in the immediate vicinity of heat
sources and do not expose to sun light�
- Cooling machine, pump motor and electronics produce
intrinsic heat that is dissipated via the venting grids (4)!
Never cover these venting grids!
Note: After setting up the device, wait at least one hour
before starting the operation to avoid the damage to the
cooling system�

Intended use

The safety of the user cannot be guaranteed:
- If the device is operated with accessories that are not sup-
plied or recommended by IKA�
- If the device is operated improperly or in contrary to the
IKA specifications�
- If the device or the printed circuit board are modified by
third parties�
Unpacking

Delivery scope:

- RC 2 GREEN basic
- Power cables
- Hose olive NW 8 (2 pieces)
- Hose olive NW 12 (2 pieces)
- Plastic cap (for "Overflow" connector)
- Plastic cap (for "Backflow" connector)
- USB 2�0 cabel (A–micro B)
- User guide
- Warranty card�

Preparations

Connecting the tubings:

- Unscrew the union nuts and stoppers using a wrench
(AF 19) from the pump connector IN (7) and OUT (8)�
- Connect the hoses for circulating the external system to the
pump connectors M 16 x 1 for IN and OUT directly or with
the olives�
Stopper
Union nut
Fig. 2
7

Advertisement

Table of Contents
loading

Table of Contents