Performing Connections To The M8199B Awg - Keysight M8199B Getting Started Manual

Performing connections to the M8199B AWG

M8100A Series Arbitrary Waveform Generators Getting Started Guide
Connecting M8008A Clock Generator to M8199B AWG Module
The unused output should be disabled on the M8070B software or
NOTE
terminated with 50 Ohms on the module hardware.
Following are the possible ways to connect a M8008A clock source to one
or more M8199B AWG modules:
Case 1 Connecting M8008A clock module to one M8199B AWG module
In this case, make the connections as described below:
1 Connect the 1.85 mm, 45 cm M8199A-810 replacement channel clock
blue cable (M8199-61624) from Sample Clk Out of M8008A to Clk In of
M8199B.
2 Connect the 3.5 mm, 50 cm M8199A-811 sync cable (M8199-61620)
from Sync Out of M8008A to Sync In of M8199B.
Figure 16
module to an M8199B AWG module:
Figure 16
on page -41 shows how to connect the M8008A clock generator
Connecting M8008A clock generator to one M8199B AWG module
Basic Setup for M8100A 2
41