Keysight M8199B Getting Started Manual page 36

2 Basic Setup for M8100A
M8199A
M8008A
36
Connecting M8008A Clock Generator to M8199A AWG Module
The unused output should be disabled on the M8070B software or
NOTE
terminated with 50 Ohms on the module hardware.
Following are the possible ways to connect a M8008A clock source to the
M8199A AWG module(s):
Case 1 Connecting M8008A clock module to M8199A AWG module
In this case, make the connections as described below:
1 Connect the 1.85 mm, 45 cm M8199A-810 replacement channel clock
cable (M8199-61624) from Sample Clk Out of M8008A to Clk In of
M8199A.
2 Connect the 3.5 mm, 50 cm M8199A-811 sync cable (M8199-61620)
from Sync Out of M8008A to Sync In of M8199A.
Figure 13
module to the M8199A AWG module:
Figure 13
on page -36 shows how to connect the M8008A clock generator
Connecting M8008A clock generator to M8199A AWG module
M8100A Series Arbitrary Waveform Generators Getting Started Guide