Keysight M8199B Getting Started Manual page 38

2 Basic Setup for M8100A
M8199A
M8008A
38
Case 3 Connecting M8008A clock module to two M8199A AWG modules
In this case, a M8008A clock module, two M8199A AWG modules, a
M9505A AXIe chassis and the following cables are required:
• 3.5 mm, 50 cm M8199A-811 customer orderable sync cable
(M8199-61620)
• 1.85 mm, 45 cm M8199A-810 replacement channel clock cable
(M8199-61624)
Make the connections as described below:
1 Connect the M8008A Clock Generator Sync Out port with both the
M8199A AWG Sync In ports using the sync cable (blue cable).
2 Connect the M8008A Clock Generator Sample Clock Out port with
both the M8199A AWG Clock In ports using clock cable (red cable).
Figure 14 on page -38 shows how to connect M8008A clock generator
module to the two M8199A AWG modules:
Figure 14 Connecting M8008A clock generator to two M8199A AWG modules
M8100A Series Arbitrary Waveform Generators Getting Started Guide