Keysight M8199B Getting Started Manual page 42

2 Basic Setup for M8100A
42
If you connect more than one M8199B module, you must perform an
NOTE
additional user calibration using the IQtools user interface to ensure that
the skew between modules is stable and corrected. For more
information, refer to the IQTools User Guide.
Case 2 Connecting M8008A clock module to two M8199B AWG modules
In this case, an M8008A clock module, two M8199B AWG modules, an
M9505A AXIe chassis and the following cables are required:
• 3.5 mm, 50 cm M8199A-811 customer orderable sync cable
(M8199-61620)
• 1.85 mm, 45 cm M8199A-810 replacement channel clock cable
(M8199-61624)
Make the connections as described below:
1 Connect the M8008A Clock Generator Sync Out port with both the
M8199B AWG Sync In ports using the sync cable (blue cable).
2 Connect the M8008A Clock Generator Sample Clock Out port with
both the M8199B AWG Clock In ports using clock cable (red cable).
Figure 17
module to the two M8199B AWG modules:
Figure 17
on page -42 shows how to connect M8008A clock generator
Connecting M8008A clock generator to two M8199B AWG modules
M8100A Series Arbitrary Waveform Generators Getting Started Guide