Page 2
• Plug-n-Play Playground Swings Vignette • 8" 3-Position Female Pigtail Power Cable • 3' 3-Position Male Pigtail Power Cable • Owner's manual The following Lionel marks are used throughout this Owner’s Manual and are protected under law. All rights reserved. Lionel ®...
Controlling the accessory Additional wiring options Connecting your accessory to FasTrack Connecting your accessory to tubular track Connecting your accessory to a transformer Wiring for TMCC or LEGACY SC-2 wiring and operation ASC wiring and operation Lionel Limited Warranty Policy & Service...
Plug-n-Play basics Wiring your accessory our Plug-n-Play Playground Swings Vignette connects to either a Plug-n-Play lock-on (6-81313) or a Plug-n-Play power block lock-on (6-81314) with a 3-pin male connector that is attached to its base. Simply plug this connector into the lock-on and apply track power.
Plug-n-Play basics Controlling the accessory lide the dog’s front paws forward and backward to turn the accessory on and off. Refer to Figure 2 for the location of this figure. Note! Within a few moments, the gears that operate the swings will activate, drawing the swings back and forth.
Additional wiring options Connecting your accessory to FasTrack ou also are able to connect your accessory to FasTrack using the included 8" 3-pin female pigtail. Plug in the 3-pin male connector from the accessory into the 3-pin female pigtail. Then attach the red wire to the inside rail and the black wire to the outside rail. See figure 3.
Additional wiring options Connecting your accessory to tubular track ou can also connect your accessory to tubular track using the included 8" 3-pin female pigtail. Plug in the 3-pin male connector of the accessory into the 3-pin female pigtail. Then attach the red wire to the inside rail position of the universal lock-on (6-24213) and the black wire to the outside rail position.
Additional wiring options Connecting your accessory to a transformer o power your accessory using a CW-80 Transformer (6-14198)or any other power supply, you will need the included 8" 3-pin female pigtail to connect to the transformer terminals. Make sure that all connections are secure. Loose connections can produce extremely high temperatures.
Page 9
Additional wiring options Connecting your accessory to a transformer continued Swing Accessory Transformer TRACK ACCESSORY 3-pin male connector 120/60z 8" 3-pin 0~18VAC 0~18VAC 3-pin female female pigtail connector Red wire Black wire 0~18VAC 0~18VAC Figure 5. Connecting your accessory to a transformer.
Wiring for TMCC or LEGACY o power your accessory in the Command Control and LEGACY environments, you will need an SC-2 (6-22980), an ASC (6-14182), or an ASC2 (6-81639). You will also need the included 8" 3-pin female pigtail and a transformer (6-14198). See figures 6 and 7 for wiring.
Wiring for TMCC or LEGACY ASC wiring and operation hree wires are needed to connect your accessory to the ASC and a separate accessory transformer. Refer to Figure 7. 1. Attach a wire to the transformer Common/Ground/U terminal and connect it to the COMM (common) position on the ASC.
Lionel LLC or any Lionel Authorized Service Station MUST be accompanied by the original receipt for purchase (or copy) from an Authorized Lionel Retailer*, will at the discretion of Lionel LLC, be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a suitable replacement is not available, Lionel will offer to replace the product with a comparable model (determined by Lionel LLC), if available.