Lionel LionChief Plus 2.0 ET44 Owner's Manual page 5

Running your locomotive
LEGACY Control operations continued
5. After selecting the ENG ID# on the Cab 2 remote, your remote needs to be
configured for TMCC or CAB1 control for the locomotive. Select the engine ID# of
your LC+ 2.0 engine as before, then press the INFO button on the top right of your CAB-2 remote.
Press the SCROLL button on the top left of the CAB-2 row until the CONTROL tab is selected. Press
the button that corresponds to the TMCC or CAB1 Mode selection on the screen. Congratulations!
You have now configured your CAB-2 remote to run your LC+ 2.0 locomotive in TMCC mode.
Enjoy all the features your locomotive has to offer.
Figure 3a. CAB-2 scroll button
Note!
If using TMCC ID 1, the ID must be programmed as a TMCC or Cab-1 locomotive. If
programmed as Legacy, your LionChief Plus 2.0 locomotive will not respond to commands.
6. Press the Start Up key on your LEGACY CAB-2 Remote, shown in Figure 4.
Then, throttle up and move 'em out! Your engine sound will start up, and the locomotive-
specific touch screen buttons will populate the remote. For more information on operating your
locomotive with the LEGACY system, please refer to the LEGACY section of this manual. Additional
information is also found in the LEGACY System Manual, available online at www.lionel.com.
Figure 2. CAB-2 info button
Custom
LIONEL TMCC
CAB1
Figure 3b. CAB-2 control screen
Figure 4. Start-up
5
ENGINE 1 INFO
Control
Type
LRS
OTH
TMCC
TMCC
LEG