ON – The audio signal routed to the output remains active when the video source
•
(coming from a different input) is deactivated.
•
OFF – The audio signal routed to the output is deactivated together with the
deactivation of the video source (coming from a different input).
To set the video lost timer (when in auto-switching mode):
1. In the Navigation pane, click Timeout Settings. The Timeout Settings page appears.
2. Set the video lost timer.
The adjustment sequence presented here is only an example. You can adjust the output
settings in any other order.
If the video is lost when in the auto switching mode (Priority or Last connected) you can set
the time the device waits before it switches to the next source.
Setting Switching Modes
Use the Auto Switch Settings page to set the switching mode per output.
Setting to priority or last connected mode forces
To set the switching mode:
1. In the Navigation pane, click Auto Switch Settings. The Auto Switch Settings page
appears.
VS-44UHDA - Using the Embedded Web Pages
Figure 37: Auto Switch Settings Page
VS-44UHDA
to operate in AFV mode.
Kramer Electronics Ltd.
43