Table of Contents
Advertisement
5.
Please remove the motor connector (CNC) from the drive:
6.
Please wire U, V, W of the motor
7.
Please screw the PE wire
8.
Please plug back above connectors to the drive. (Power and Motor)
9.
Please fixe the FG wire from the motor cable to the drive
Or
In case of using the shield clamp, please attach the cable to the clamp in order to
connect the shielded section.
10.
Please plug the encoder cable to the drive (CN2)
Additional Information
For further details about wiring method, please refer to 1S-series AC Servomotors and Servo Drives
User's Manual (with Built-in EtherCAT Communications) (Cat. No. I586)
(stripped wires)
of the main power to the drive.
21
Advertisement
Table of Contents
