Table of Contents
Advertisement
Only for Type 190/94
Moving with load (A) - operation
fast moving operation (B) - by fixing the crank on the other
crank pin (B) it is possible to increase the lifting range per
crank turn
NOTICE!
In case of fast moving operation (B), the crank can only be
turned anti-clockwise - the load can only be lifted.
Disengaging of the rope drum
Pulling out the uncharged wirerope:
Lift the shank bolt (D) by hand and pull out the medial crank
pin (B) with the crank (C) and let the cam catch engage.
Winding up of the uncharged wirerope:
Turn the medial crank pin (B) anti-clockwise.
CAUTION!
It is not permitted to disengage the drum under load.
8
Commissioning
8.1
General
Should the unit be used in Germany:
Please observe the validated, national accident prevention regulations.
For other countries:
Inspections as above. Please observe the national rules and regulations and the instructions in this manual!
NOTICE!
Hoists up to 1000 kg capacity and without motor-driven trolleys of hoisting unit must be tested by a "qualified
person" before putting into operation for the first time.
Hoists of 1000 kg capacity and up or with more than one motor-driven hoist movement; i.e. lifting and trolley
movement, must be tested by a "licensed qualified person" before putting in operation.
An exception is "hoists ready for operation" acc. validated national regulations with EU-declaration of
conformity.
Definition "qualified person" (former expert)
A "qualified person" has learned, due to occupational training and experience and the job that the person has
done, the skills needed to tests the material for one's work.
Definition "licensed qualified person" (former approved expert)
A "licensed qualified person" has, due through special occupational training, knowledge about testing of the
material for one's work and knows the national accident prevention regulations and other prescriptions and
technical regulations. This person must test the material for one's work regularly with regard to design and
kind of use. The license will be given to qualified person be the approved supervision authorities (ZÜS).
8.2
Wire rope
Wire ropes must be free from corrosion, dirt or damage.
They must be lubricated before commissioning.
No lubrication shortens the lifetime of the wire rope and the maintenance intervals.
WARNING!
It is not allowed to use plastic wire ropes or plastic-coated wire ropes.
10
5.52.248.00.01.02
Advertisement
Table of Contents
