Brake As Slipping Clutch To Disengage The Drum; Commissioning; General; Worm Gear - HADEF 238/10-EX Installation, Operating And Maintenance Instruction

DANGER!
The following is not allowed:
 Disengaging under load.
 Manipulation of the disengaging device.
7.2

Brake as slipping clutch to disengage the drum

Adjustment of the slipping clutch
 4 Loosen the safety screws (1)
 Adjust the slipping clutch at the set ring (2)
direction A = brake pressure increases,
direction B = brake pressure decreases
 4 Tighten the safety screws (1) again.
8

Commissioning

8.1

General

The operator of the unit is responsible for the entire system.
According to the Ordinance on Industrial Safety and Health, a hazard analysis must be carried out by the
operator.
Observe the respective national standards, regulations and directives of the responsible bodies at the place
of operation.
NOTICE!
Hoists up to 1000 kg capacity and without motor-driven trolleys of hoisting unit must be tested by a
"qualified person" before putting into operation for the first time.
Hoists of 1000 kg capacity and up or with more than one motor-driven hoist movement; i.e. lifting and
trolley movement, must be tested by a "licensed qualified person" before putting in operation.
An exception is "hoists ready for operation" acc. validated national regulations with EU-declaration of
conformity.
Definition "qualified person" (former expert)
A "qualified person" has learned, due to occupational training and experience and the job that the person has
done, the skills needed to tests the material for one's work.
Definition "licensed qualified person" (former approved expert)
A "licensed qualified person" has, due through special occupational training, knowledge about testing of the
material for one's work and knows the national accident prevention regulations and other prescriptions and
technical regulations. This person must test the material for one's work regularly with regard to design and
kind of use. The license will be given to qualified person be the approved supervision authorities (ZÜS).
8.2

Worm gear

In order to guarantee long product lifetime, we recommend to
operate the winch for some time long at the start.
Effect approx. five full drum rotations with approx. 50% of the
nominal load.
Remove the protection plate and distribute the fat with a paint
brush over the worm gear wheel and the shaft.
5.52.208.01.01.02
Illustration 6
15