Table of Contents
Advertisement
13.5
Lubricant for food industry – Selection (as option*)
SHELL
Gearing
FM Grease HD2
Load chain
--
Load hook;
Pulleys
FM Grease HD2
Gear rim;
Drive pinion
* must be mentioned by order
14
Trouble
Please pay attention to the following in case of problems:
Troubles with the equipment must only be repaired by qualified personnel.
Secure the unit against unintended operation start.
Put up a warning note indicating that the unit is not to be used.
Secure the working area of moving parts of the unit.
Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
15
Remedy
Trouble
Load is not lifted
Load pressure brake does not open.
16
Decommissioning
WARNING!
It is essential that the following points are observed in order to prevent damage to the equipment or critical
injury when the device is being decommissioned:
It is mandatory that all steps for decommissioning the machine are carried out in the indicated sequence:
First secure the working area for decommissioning, leaving plenty of space.
Read the chapter "Safety instructions".
Disassembly is carried out in reverse order to the assembly.
Please make sure that all operating material is disposed of in accordance with environmental regulations.
16.1
Temporary decommissioning
Measures are as above.
Also read the chapter "Transport and storage".
16.2
Final decommissioning/disposal
Measures are as above.
After disassembly, ensure that the disposal of the equipment and any materials it contains is carried out
in accordance with environmental regulations.
5.52.248.00.01.02
MOBIL
CASTROL
--
Mobilgrease FM 222
Optimol Viscoleb 1500
Lubricant FM 100
--
Mobilgrease FM 222
Cause
Rope is not winded correctly - rope turning direction for
lifting is not correct
Brake is worn or defective.
brake discs are humid or oiled
Brake mechanism or brake discs are locked.
KLÜBER
Klüberoil 4UH 1-1500 N
--
--
Remedy
Place the wire rope correctly
Check brake parts and replace parts that are worn.
Repair or overhaul of the brake system
Loosen the brake by slightly pushing the winch handle by
hand (in direction lowering)
13
Advertisement
Table of Contents
