Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
Steps
1. Place the camera and camera bracket in the slot on the retractable-camera assembly and snap it in place.
2. Align the screw holes on the camera-assembly cover with the screw holes on the retractable-camera assembly.
3. Replace the three screws (M3x5) that secure the camera-assembly cover to the retractable-camera assembly.
4. Press the top of the retractable-camera assembly to retract the retractable camera.
5. Route the camera cable through the routing guides on the display-assembly base.
6. Place the retractable-camera assembly on the display-panel base.
7. Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
8. Connect the camera cable to the system board.
Post-requisites
Steps
1. Replace the
system-board
2. Replace the
back
cover.
3. Replace the stand.
38
Replacing the camera
computer. After working inside your computer, follow the instructions in
shield.
Replacing the camera
24
After
www.dell.com/
Advertisement
Table of Contents
