Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Adhere the camera to the camera frame.
2
Connect the camera cable to the camera module.
3
Press the camera frame down into the slot on the display bezel until it snaps into
place.
4
Route the camera cable and antenna cable through the routing guides on the
display-assembly base.
5
Connect the microphone and camera cable to the system board.
Post-requisites
1
Replace the
system-board
2
Replace the
back
3
Follow the procedure in step 4 in
4
Replace the stand.
computer. After working inside your computer, follow
After working inside your
shield.
cover.
"Replacing the optical
computer. For more safety best
www.dell.com/
drive".
Before
53