Exchanging Replacement Parts - Bredel 40-100 Operating Manual

8.8

Exchanging replacement parts

Replacing the pressing shoes
A
B
1. Jog the motor until the pressing shoe (B) is positioned in view of the inspection window (A).
2. Isolate the pump from the electrical supply.
D
B
A
Note: The drain plug is in the bottom of the pumphead.
3. Place a tray (A) under the drain plug. The tray must be large enough to contain the lubricant,
possibly contaminated with product fluid, from the pumphead. Remove the drain plug (B).
Collect the lubricant from the pump housing in the tray.
4. Drain as much Bredel Genuine Hose Lubricant until the level has lowered just below the
inspection window (D).
5. Check the sealing ring (C) is not damaged and replace it if necessary.
6. Position the drain plug and tighten it to the specified torque.
65
C
m-bredel-40-100-en-05