Placing The Pump - Bredel 40-100 Operating Manual

A
The complete hose pump, i.e. pumphead, gearbox and electric motor, must be lifted using the lifting
point of the pumphead plus additional support using suitably rated straps or slings (A). Never exceed
the maximum rating of the lifting point of the pumphead.
5.5

Placing the pump

Do not use holes (B) when the pump is placed on the leveling elements. This
can cause the pump to tilt.
Do not use the holes in the pump supports to lift the hose pump.
The pump can be fixed to the floor using anchors. Alternatively the pump can be placed on the floor
using levelling elements.
C
B
•
In case of fixing to the floor use holes (A) or (B) and holes (C) at both sides of the pump.
•
In case of levelling elements, use holes (A) and holes (C) at both sides of the pump.
Note: If the pump installation position is in position 4, then the use of levelling elements is not
possible.
m-bredel-40-100-en-05
A
33