Changing Oil In The Gearbox - Bredel 40-100 Operating Manual

5. Keep on pouring until the lubricant level has risen above the level line in the inspection
window. Place back the breather cap.
See also
For the required quantity of lubricant, Refer to "Lubricant table pump" on page 94
Refer to "Torque figures" on page 95
8.6

Changing oil in the gearbox

1. Isolate the pump from the electrical supply.
C
2. Place a tray under the gearbox.
3. Remove the plug (A) and drain the gearbox.
Note: The plug (A) is magnetically loaded. In this way metal particles in the oil are pulled to the plug.
4. Clean the plug and remove any metal particles if necessary. Check that the sealing ring is not
damaged and replace it if necessary.
5. Place the plug back in the gearbox and tighten it firmly.
6. Remove the level plug (B) and breather (C). Position a funnel in the hole of breather (C) and fill
the gearbox with oil until the oil just comes out of the level plug hole (B). Place level plug (B)
and breather (C) back and tighten them firmly.
53
B
A
m-bredel-40-100-en-05