Using The Operation Panel To Move Cartridges; Load Cartridge Into Drive; Figure 4-10 Move Cartidge; Figure 4-11 Select Source Screen - NEC LL030F User Manual

4.7 Using the operation panel to move cartridges

4.7.1 Load cartridge into drive

The following describes how to use the operation panel to move a cartridge from a specified
magazine slot into the drive.
In this example, the cartridge in slot 1 will be loaded into the drive #1.
1) [Login]. See Section 4.3Login for detail.
2) Select [Commands].
3) Select [Move Cartridge] from [Commands].
4) The screen to specify the Source and Destination is displayed.

Figure 4-10 Move Cartidge

5) Select [slotxx] under [Source], and the slot where the cartridge is stored is displayed.
In this example, select slot01.

Figure 4-11 Select source Screen

-69-