Table 4-1 Library Status displayed in the Operation Panel
Message
PLEASE INSERT MAGAZINE
MAGAZINE UNLOCKED
PLEASE CLOSE I/O STATION
INITIALIZING・・・
INVENTORY・・・
SETTING・・・
** CHK **
[XXXX]
RECOVERING・・・
PLEASE WAIT
LIBRARY FIRMWARE
UPDATING!
DRIVEn FIRMWARE
UPDATING!
DRIVE DUMP DATA
UPLOADING!
EXCHANGE SLOTFULL
CARTRIDGE WRONG
INSERTION
ENDURANCE
COUNT OVER
OFFLINE
CLEANING...
REPLACE CLEANING MEDIA
CLEAN DRIVEn
PSU n FAULT
PSU n FAN ERROR
REDUNDANT PSU ERROR
Drive n FAN ERROR
READY
2. Accessor status display section
Indicates whether a cartridge tape exists in the picker section of the accessor.
Description
Magazine insertion is requested.
Magazine is not locked.
I/O Station CLOSE is requested.
Initialization is in progress.
Inventory is in progress.
Setting in progress
Library error status (xxxx is the CHK code)
Library firmware is in recovery.
Library firmware update is in progress.
Drive firmware update is in progress.
Dump data is being uploaded from drive.
A cartridge is stored in the exchange slot.
A cartridge has been incorrectly inserted in the drive.
The number of Accessor mechanism operations has reached
the expected life (endurance) value
Library Offline(Not Ready)
During drive cleaning
(This status message is displayed in doing "Clean Drive")
Replacement of cleaning cartridge
Drive n cleaning is requested
Power module error
Power module fan error
Redundant power module error
Drive FAN error
Ready(Idle)
Figure 4-3 Accessor Icon
-34-
(With no cartridge tape)
(with cartridge tape)